Table of Contents
Advertisement
5. If blade is not at 90 degrees, open the motor
cover door, loosen lock nut (A, Fig. 19) and
turn adjusting stop screw (B, Fig. 19) on the
front trunnion in, or out. The adjusting stop
screw should stop against the front trunnion
bracket when the blade is 90 to the table.
6. Tighten the lock nut (A, Fig. 19).
7. Set the blade at 45 degrees to the table by
turning the blade tilting handwheel counter-
clockwise as far as it will go.
combination square on the table against the
blade. Make sure square is not touching a
blade tooth.
8. If the blade is not 45 degrees, remove the
raising and lowering handle. Loosen lock nut
(A, Fig. 19) and turn adjusting stop screw
(B, Fig. 19) on the front trunnion in, or out. The
adjusting stop screw should stop against the
front trunnion bracket when the blade is 45 to
the table.
9. Check the accuracy of the pointer (C, Fig. 20)
on the angle scale and adjust, if necessary.
Assembly and adjustment of the saw are now
complete. Make sure all fasteners are tight. The
saw may now be placed into operation.
Changing the Belt
Make all machine adjustments
or maintenance with the machine unplugged
from the power source. Failure to comply may
cause serious injury!
Referring to Figure 21:
1. Disconnect the machine from the power
source, unplug.
2. Lower the blade to its lowest point.
3. Loosen two hex cap bolts (A).
4. Take the tension off of the belt (B) by lifting up
on the motor.
5. Remove the belt from the arbor and motor
pulleys.
6. Replace and tension the belt. The weight of the
motor should apply enough tension to the belt.
Tighten the hex cap bolts (A).
7. Check the belt tension after the saw has been
used for a few hours. Adjust as necessary.
Place a
16
Figure 19
Figure 20
Figure 21
Advertisement
Table of Contents
