Front Guide Rail; Switch Bracket - Jet JWTS-10JF Operating Instructions And Parts Manual

Front Guide Rail

Required Fastening Hardware:
A – 1 ea – Connecting Plate
C – 2 ea – Socket Head Cap Screws (1/4)
D – 2 ea – Lock Washer (1/4)
E – 2 ea – Flat Washers (1/4)
G – 4 ea – Flat Head Screws (5/16x1-1/4)
H – 2 – Flat Washers (5/16)
J – 2 – Hex Nuts (5/16)
Required Tools:
5mm Hex wrench
12mm wrench
Cross point screwdriver
Referring to Figure 10:
1. Place the connecting plate (A) into the long
front rail section (B), lining up the mounting
holes. Insert a 1/4" socket head cap screw (C),
1/4" lock washer (D), and 1/4" flat washer (E)
through the rail; thread into the connecting
plate (A) and tighten firmly using a 5mm Hex
wrench.
2. Join the short front rail section (F) to the long
front rail section and secure to the protruding
end of the connecting plate in the same
manner as described in step 1.
3. Attach the front guide rail to the saw table (L)
and right extension wing only (K) using three
5/16" x 1-1/4" flat head screws (G).
Note: A flat washer (H) and hex nut (J) is used
to fasten the rail to the right extension wing.
4. Tighten firmly the two screws holding the rail to
the table. Do not tighten the screws holding the
rail to the right extension wing at this time.

Switch Bracket

Referring to Figure 11:
Place the switch bracket (A) behind the front lip of
the left extension wing so that the hole in the switch
bracket lines up with the hole in the guide rail and
extension wing (B). Insert a 5/16" x 1-1/4" flat head
screw through the guide rail, extension table, and
switch bracket and secure with a 5/16" flat washer
and 5/16" hex nut. Hand tighten only at this time.
14
Figure 10
Figure 11