Assembling The Saw To The Stand; Dust Hood; Handwheels And Lock Knobs - Jet JWTS-10JF Operating Instructions And Parts Manual

Assembling the Saw to the Stand

Do not plug the table saw into
the power source until all assembly has been
completed! Failure to comply may cause
serious injury!
5. Turn the stand upside down and place onto
the table saw (Figure 3)
Note: The side with the JET logo is the front
side of the stand and will be on the same side
as the Warning label on the table saw.
Line up the holes in the top plates of the stand
with the holes in the table saw so that the front
of the stand is flush with the front of the saw.
The sides of the stand should also be flush
with the sides of the saw.
6. Attach the saw to the stand with four M8x30
hex cap screws, eight M8 flat washers, four
M8 lock washers and four M8 hex nuts using
Figure 4 as a guide. Tighten the saw to the
stand hardware firmly.
Note: Do not turn the saw over until the dust hood
(next section) is installed.

Dust Hood

1. Place the dust hood (Figure 5) onto the stand
and align the holes in the stand with the holes
in the dust hood. Attach the dust hood to the
stand using four M6x20 hex cap screws, four
M6 flat washers, four M6 lock washers, and
four M6 hex nuts. Tighten the dust hood
hardware firmly.
2. Carefully turn the table saw on to the stand
feet.
Important: Turn the saw over toward the front
to avoid damaging the connecting rods on the
rear of the saw.
The table saw should be in its final location.
Make sure the saw is sitting level and tighten
all stand hardware.

Handwheels and Lock Knobs

1. Thread the handle into the handwheel
(Figure 6) and tighten with a 14mm wrench.
2. Slide the handwheel (A, Fig. 7) onto the shaft
on the front of the table saw. Make sure that
the slot in the handwheel hub engages the roll
pin.
3. Fasten in place with a lock knob (B, Fig. 7).
4. Repeat with the other handwheel, shaft, and
lock knob (C, Fig. 7) on the right side of the
table saw.
12
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7