Extension Wings; Rear Guide Rail - Jet JWTS-10JF Operating Instructions And Parts Manual

Extension Wings

Referring to Figure 8:
1. Attach an extension wing (A) to the table (B) on
the right side using three M10x20 hex cap
screws (C), three M10 lock washers (D), and
three M10 flat washers (E). Hand tighten only
at this time.
2. Repeat for the left side.

Rear Guide Rail

Referring to Figure 9:
Required Fastening Hardware:
A – 1 ea – Connecting Plate
C – 2 ea – Socket Head Cap Screws (1/4)
D – 2 ea – Flat Washers (1/4)
G – 4 ea – Socket Head Cap Screws (5/16x1)
H – 4 ea – Spacers
J – 2 – Flat Washers (5/16)
K – 2 – Hex Nuts (5/16)
L – 2 ea – Lock Washer (1/4)
Required Tools:
5mm Hex wrench
12mm wrench
1. Place the connecting plate (A) into the long
rear rail section (B), lining up the mounting
holes. Insert a 1/4" socket head cap screw (C),
1/4" lock washer (L) and 1/4" flat washer (D)
through the rail; thread into the connecting
plate (A) and secure tightly using a 5mm Hex
wrench.
2. Join the short rear rail section (E) to the long
rear rail section and secure to the protruding
end of the connecting plate in the same
manner as described in step 1.
3. Insert two 5/16x1 socket head cap screws (G)
into the middle
assembled rear rail. The screws should be
inserted through the side with the larger
opening.
4. Place spacers (H) on the protruding threaded
ends of the screws, then partially secure the
rail to the threaded mounting holes on the rear
of the table.
5. Insert two 5/16x1 socket head cap screws (G)
into the outer mounting holes of the rear rail.
Place spacers (H) on the ends of the screws,
then insert the screws through the mounting
holes of the extension wings, securing them
with 5/16 flat washers (J) and 5/16 hex
nuts (K).
mounting holes of the
6. Tighten firmly the two screws holding the rail to
the table. Do not tighten the screws holding the
rail to the extension wings at this time.
13
Figure 8
Figure 9