Unpacking And Cleanup; Stand Assembly - Jet JWTS-10JF Operating Instructions And Parts Manual

Assembly
Read
assembly instructions
assembly! Failure to comply may cause
serious injury!

Unpacking and Cleanup

1. Finish removing all contents from the shipping
carton. Keep the saw table upside down
(Figure 1) and place on a two-by-four or similar
piece of wood under the rear of the saw. This
will help when picking up the table again. Do
not discard the carton of packing material until
the saw is assembled
satisfactorily.
2. Inspect the contents for shipping damage.
Report damage, if any, to your distributor.
3. Compare the contents of the shipping carton
with the contents list in this manual. Report
shortages, if any, to your distributor.

Stand Assembly

Refer to Figure 2.
Tool required – 13mm wrench
The stand is assembled using 40 each of the
following: M8x16 carriage bolts (C), M8 flat
washers (D), M8 lock washers (E), and M8 hex
nuts (F).
1. Assemble the legs (A) to the long top
plates (B). Hand tighten only at this time.
2. Assemble the short top plates (G) to the stand
legs (A) using the same combination of
hardware as used to attach the long to plates.
Note that the short top plates fit over the long
top plates. Hand tighten the hardware only at
this time.
3. Assemble the long support plates (H) to the
inside of the stand legs with the same M8
hardware. Hand tighten only at this time.
4. Assemble the short support plates (J) to the
inside of the stand legs with the same M8
hardware. Hand tighten only at this time.
and understand all
before attempting
and is running
11
Figure 1
Figure 2