Motor And Guard Bracket - Jet JWTS-10JF Operating Instructions And Parts Manual

2. Remove the motor plate shaft (A, Fig. 21) from
the motor bracket (B, Fig. 21).
3. Position the large slot on the motor plate under
the motor bracket and raise the motor plate to
align the holes for the motor plate shaft. The
flat surface of the motor plate is on top.
4. Insert the motor plate shaft (A, Fig. 21) into the
motor plate and through the motor bracket until
it passes through the motor plate on the
opposite side. Make sure that the groove on
the motor plate shaft lines up with the hex cap
screw (D, Fig. 21) on the motor bracket.
5. Tighten the hex cap screw (B, Fig. 21) on the
motor bracket to secure the motor plate shaft.

Motor and Guard Bracket

This portion of the assembly procedure requires
placing the motor and guard bracket onto the motor
plate. This can be a somewhat awkward process.
It is strongly recommended to
complete the motor
assembly with assistance to avoid injury.
1. Place four M8 flat washers over four M8 x 25
hex cap screws and place on the saw table
within easy reach.
2. Place the belt guard bracket (A, Fig. 22) on top
of the motor plate (B, Fig. 22). The hole for the
motor pulley (C, Fig. 22) should be on your left
as you face the rear of the saw.
3. Place the motor on top of the belt guard plate
and line up the holes in the motor mount, the
belt guard bracket, and the motor plate.
4. Hold the motor in place with four M8 x 25 hex
cap screws, eight M8 flat washers, four M8 lock
washers, and four M8 hex nuts. Tighten the
hardware to hold the motor in place but loose
enough to make adjustments.
5. Using an accurate straight edge (A, Fig. 23),
line up the motor pulley (B, Fig. 23) with the
arbor pulley.
6. Position the belt
approximately 1/8" from the end of the motor.
Note: Before tightening the motor mounting
hardware, position the motor as far forward on the
mounting plates as possible. This gives the belt
more positive friction when the blade is tilted to a
45º angle.
7. Tighten the motor mounting hardware.
and guard bracket
guard (C, Fig. 23)
18
Figure 21
Figure 22
Figure 23