Hardware Bag For Stand Assembly; Tools Required For Assembly; Assembly; Unpacking And Cleanup - Jet JWBS-14OS-M Operating Instructions Manual

Hardware Bag for Stand Assembly

01 – Carriage Bolt M8x16 (40)
02 – Serrated Hex Flange Nut M8 (40)
Hardware Bag for Stand Assembly

Tools Required for Assembly

1 Accurate Straight Edge (approximately 2 ft)
1 Cross-point Screwdriver
1 6mm Hex Wrench
1 10mm Box Wrench
1 13mm Box Wrench
Note: Use of sockets and ratchets will speed
assembly time but are not required.

Assembly

Read and understand all
assembly instructions
assembly! Failure to comply may cause
serious injury!
The required hardware for all assembly on this
machine is found in the Hardware Bag for Stand
Assembly and Hardware Bag for Saw Body.

Unpacking and Cleanup

1. Finish removing all contents from the
shipping carton. Do not discard the carton or
packing material until the bandsaw is
assembled and is running satisfactorily.
2. Inspect the contents for shipping damage.
Report damage, if any, to your distributor.
3. Compare the contents of the shipping carton
with the contents list in this manual. Report
shortages, if any, to your distributor.
before attempting

Stand

Referring to Figure 1.
1. Assemble the legs (A) to the table (B). Each
leg requires 6 ea M8 x 16 carriage bolts (C)
and 6 ea M8 flange nuts. Hand-tighten only
at this time.
2. Assemble the long plates (E) to the legs (A).
Each plate requires 4 ea M8 x 16 carriage
bolts (F) and 4 ea M8 flange nuts (G). Hand-
tighten only at this time.
3. Assemble the short plates (H) to the legs
(A). Each plate requires 4 ea M8 x 16
carriage bolts (J) and 4 ea M8 flange
nuts (K).
4. Slip the rubber feet onto the ends of the
legs (L)
5. Ensure that the stand is on a level surface
and all four legs are contacting the surface.
6. Tighten all flange nuts with a 13mm socket
or wrench.
8
Figure 1