Setting Up Your Monitor - Angelcare Movement Monitor Instruction Manual

Setting up your monitor

POSITION OF SENSOR PAD UNDER MATTRESS
MIDDLE OF THE CRIB
Correct
A
Sensor Pad
Figure 1
Figure 3
"Tic" On/Off
button
Front view
• Connect the Sensor Pad cord to the Nursery Unit.
• Place the Sensor Pad in the middle of the crib under the mattress, as illustrated besides.
Make sure the printed side faces up. Do NOT place any bedding between the mattress and
the sensor pad.
• Secure the sensor pad cord to crib using a tie wrap. Run the cord on the floor to ensure
it is out of the baby's reach.
• The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring or
slat base, place a hard board between the crib base and the Sensor Pad measuring at least
13" x 13" (33x33 cm) and 1/4 inch (6 mm) thick. Make sure the sensor pad's cord passes
underneath the mattress as shown above.
• The sensor pad works with all baby bed sizes and all mattresses, except memory foam
mattresses.You will have to test your sensor pad on STEP 1.
• Once you are done using the Sensor Pad, please remove it from the baby's crib and store it
away.
• The Angelcare Sensor Pad feature is not designed for use with adults, children or infants
older than 24 months.
WARNING
STRANGULATION HAZARD - Children have STRANGLED in cords. Keep the sensor
pad cord out of the reach of children. Do not put the Nursery Unit inside a crib
or play yard. Because of the serious strangulation risk to infants and toddlers,
parents and caregivers should never place the nursery unit within 3 feet
(1 meter) of a crib.
IMPORTANT
Keep at
least 1m
(39 inches)
apart
Antenna/Night Light
Power On/Off switch
"Tic" indicator
Alarm indicator
Low battery indicator
B Incorrect
Sensor Pad
Figure 2
Movement
sensitivity
adjustment dial
Sensor Pad socket
Battery compartment
(2-AA batteries)
Back view
8
Figure 4
Sensor Pad