Wall Switch Kit Installation - Valor 1500IN Installation & Owner's Manual

QUALIFIED
INSTALLER
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR THE BATTERY BOX
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
The wall switch kit is connected to the receiver in
the fi replace. The receiver is located on the left side
of the appliance, left of the control valve behind the
appliance's front panel. The battery box is located on
the right hand side of the appliance under the fi rebox.
1. Decide where the switch is to be installed on the
wall. Install an electrical outlet box (not supplied) to
house the switch controls.
2. Thread the switch wire through an access hole in
the appliance.
CAUTION
Do not run the switch wire over the top of the
fi rebox. Route the wire so it does not contact the
fi rebox.
3. Pull out the receiver and the battery boxes. Remove
the batteries from the receiver or battery box if
they contain any. You can remove the ignition wire
to improve access to the receiver.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box!
This could cause a short circuit to the receiver.
4. Take the switch wire and plug it into the receiver's
connection slot as indicated (the other slot should
already be fi tted with the valve's wire harness
connector). See diagrams below.
IMPORTANT: The connection can only be done
one way. Do not force it or damage the pins!
5. On the outside of the fi replace, run the switch wire
into the outlet box.
6. Plug the wire into the switch plate and to the outlet box.
7. Reconnect the ignition wire to the receiver if it was
previously removed.
IMPORTANT: Make sure the ignition wire DOES
NOT TOUCH the receiver's antenna.
CAUTION
To avoid short-circuit to the receiver, position
the antenna so that it DOES NOT TOUCH the
ignition wire.
48

Wall Switch Kit Installation

Wall Switch Harness
Valve Wire Harness
Ignition Wire Connection
(spade type connector)
Be careful when removing
and reinstalling: not to
bend or break the spade
Receiver
The receiver and battery box are located inside
the front panel of the appliance.
IMPORTANT: The connection
can only be done one way.
Do not force it or damage the
pins on the receiver box!
Antenna
connector
Battery box
Ignition Wire