Replacing The Flip Detect Magnet - Motorola MOTOKRZR K1m Service Manual

Level 1 and 2 Service Manual

Replacing the Flip Detect Magnet

6809504A60-A
If the flip inner housing assembly needs to be replaced, obtain the new assembly
and use the following procedure:
1. On the new flip inner housing assembly, add a small drop of the glue on the
bottom of the magnet opening shown in Figure 40 below.
2. Insert the magnet and press firmly until the magnet is even with the top of the
slot in the opening.
Figure 40. Installing the New Flip Detect Magnet
The magnet fits tightly and some glue may squeeze out. It is not necessary to
wipe off the excess glue.
3. Reassemble the remainder of the unit.
4. Verify that the flip detect feature is working by closing and opening the flip
and observe how main/cli displays respond. The display should revert back to
the home screen. The Mototriage flip detect test can also be used.
March 09, 2007
Disassembly
070374o
43