Removing And Replacing The Flip Assembly - Motorola V551 Service Manual

Gsm quad-band wireless telephone

Hide thumbs Also See for V551:

Table of Contents

Disassembly

Removing and Replacing the Flip Assembly

Remove the battery cover, battery, SIM card, antenna, rear housing, and

transceiver board assembly as described in the procedures.

Insert a small screw driver between the flip assembly and the flip knuckle.

Carefully and gently bend the front housing knuckle away from the flip

assembly hinge to separate the flip assembly from the front housing as shown

in Figure 12.

Carefully lift the flip assembly away from the front housing assembly.

Carefully thread the flip assembly flex cable through the slot in the front

housing assembly.

Flip Assembly

Front Housing

Figure 12. Removing the Flip Assembly

To replace, carefully thread the display flex cable through the slot in the front

housing.

Insert the side of the hinge of the flip assembly with the flex cable into the

knuckle.

Gently slide the other end of the flip hinge into position into the knuckle.

Replace the transceiver board assembly, rear housing, SIM card, antenna,

battery, and battery cover as described in the procedures.

September 28, 2004

V551 GSM

Flip Assembly Hinge

Flip Assembly Knuckle

6809490A38-O

Table of Contents

V555