Disassembly
Removing and Replacing the Flip Assembly and Transceiver Board
36
5.
Lift the keyboard stiffener away from the phone.
6.
To replace, align the keyboard stiffener to the transceiver board.
7.
Connect the keyboard flex connector to its socket on the transceiver board.
8.
Lower the keyboard stiffener onto the transceiver board.
9.
Insert and tighten two screws near the polyphonic speaker assembly.
10. Replace the speaker cover, keypad bezel, antenna, battery, and battery cover
as described in the procedures.
1.
Remove the battery cover, battery, antenna, keypad bezel, speaker cover, and
keyboard stiffener as described in the procedures.
2.
Use the disassembly tool to disconnect the flip assembly flex connector. (See
Figure 17).
Flip Flex
Connector
disassembly tool
Figure 17. Removing the Flip Assembly Flex Connector
June 07, 2004
A840
032216o
6809485A78-O