Removing And Replacing The Flip Housing - Motorola V180 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Flip Housing

6809485A79-O
1. Remove the battery cover and battery, SIM, antenna, rear housing, transceiver
board assembly, keypad, microphone, CLI Lens as described in the procedures.
2. Use a T6 driver to remove the 4 bracket overshield screws from the flip
assembly (see Figure 12). Set the screws aside for re-use.
Flip Housing
Disassembly Tool
Figure 12. Removing the Flip Housing
3. Use the disassembly tool to unlatch the flip housing on each side.
4. When both sides of the flip housing are unlatched, lift the flip housing away
from the flip assembly.
5. To replace, align the bracket to the flip assembly.
6. Slide the bracket onto the flip housing. Ensure the bracket holes align with the
flip assembly screw bosses.
July 08, 2004
Bracket Screws
Bracket Screws
Disassembly
Bracket S
040445o
31