Setting Up The Dvr Unit; Installing The Hard Disk - Avermedia AVerDiGi MOB1304 NET User Manual

1.4

Setting Up the DVR Unit

1.4.1 Installing the Hard Disk

The DVR unit allows you to install one SATA hard disk.
i
- For hard disk spec, please referring to
→ Mobile DVR → AVerDiGi MOB1304 NET → Hardware Recommendations
- The DVR unit support hot swapping. Therefore, user can swap the hard disk without
shutdown the DVR unit.
The "compatible hard disks" indicated in the above recommendation list only means that these
commercially available hard disks were tested with AVerMedia products and functioned well
under normal operation conditions. AVerMedia does not guarantee or provide warranties,
explicitly, implied or statutory with respect to the reliability of the hard disk function or its
compatibility. In no event AVerMedia shall be liable for damages, with respect to any business
interruption of clients, lost profits, loss of programs or other data on your information handling
system or otherwise. This includes direct, indirect, incidental, special, or consequential
damages, resulting from the incompatibility caused by the usage of these hard disks, even if
AVerMedia has expressly advised about the risk of such damages. The entire risk arising out of
the use of any information attached here with is borne by the recipient.
Follow the illustrated instructions below to install the hard disk:
1. Using key to unlock the hard disk key lock
3. Connect the SATA cable to the connector that inside
of hard disk drawer.
http://www.avermedia.com/AVerDiGi/
2. Pull removable hard disk drawer out
4. Connect another side of SATA cable to the hard
disk.
4
→ Products