Troubleshooting Procedures - Sun Microsystems W1100z User Manual

7. Replace the left-side panel.
8. Reconnect the system and any attached peripherals to their power sources, and
then power them on.
2.2

Troubleshooting Procedures

TABLE 2-1
workstation. Possible solutions are listed for each problem. If the solutions listed
here do not fix the problem, run the appropriate diagnostic test (see
TABLE 2-1
Problem
Workstation does
not power on when
the front panel
power button is
pressed.
Workstation does
not power off when
the front panel
power button is
pressed.
The network status
indicator does not
light up.
An external device
connected to a USB
connector does not
work.
Cannot eject
CD-RW/DVD-ROM
tray
contains possible problems that might arise during the use of your
Troubleshooting Procedures
Possible solution
• Make sure the power button on the front panel is turned on (the
platform power LED on the button should be lit).
• Make sure the power cable is connected correctly.
• Make sure that the wall outlet has power. Test it by plugging in
another device.
• Try all of the power-off options shown in
Off the Workstation" on page
• If the workstation still does not power off, disconnect the power
cable from the rear of the chassis.
• Check the cabling and network equipment to make sure that all
cables are correctly seated.
• Reinstall the network drivers.
• Reduce the number of external devices connected to a USB hub.
• Refer to the documentation that comes with the device.
Insert the tip of a pen or paper clip into the ejection opening on the
CD-RW/DVD-ROM drive tray.
Chapter
Section 1.4.2, "Powering
1-10.
Chapter 2 Troubleshooting
3).
2-3