Installing A Pci Or Agp Card - Sun Microsystems W1100z User Manual

4.5.5.3 Reconfiguring the System Memory
The system automatically detects the amount of memory installed. Run the BIOS
setup to view the new value for total system memory and make a note of it.
4.5.6

Installing a PCI or AGP Card

This procedure describes how to install a typical PCI card (including the host bus
adapter) or AGP card. PCI and AGP cards may vary in the way in which they are
installed in the system. For example: PCI cards may be either full-length cards or
half-length cards; AGP cards are secured in the AGP card slot with a latch. Visually
inspect each card to determine its mounting requirements before beginning this
procedure.
To install a PCI or AGP card:
1. Turn off the system and all of the peripherals connected to it, then unplug the AC
power cord from the system.
2. Remove the left-side access panel.
3. Gently lay the system on its right side on a stable, non-slip surface.
4. Refer to the Service Label, attached to the inside of the access panel, to choose an
empty card slot that is compatible with the card that you are installing.
5. Working from inside the chassis, compress the blue retention clip (securing the
selected slot cover) until it passes through the cutout in the rear panel (see (1) on
FIGURE 4-22
6. Pull out the slot cover (see (2) on
Keep it for reassembly later.
). Then pivot the clip outwards.
).
FIGURE 4-22
Chapter 4 Maintaining the Workstation 4-31