System expansions
1
►
Push the hard disk drive into the casing (1) until the EasyChange rails engage.
►
Connect the data and power supply cables to the hard disk drive or to the hard disk drives.
IDE interface:
i
Connect the blue plug of the data cable to the connection on the mainboard. Connect the
plug on the other end to the hard disk drive.
Serial ATA interface:
Connect the angled plug of the data cable to the drive and the straight plug to the
connection on the mainboard.
Even if your serial-ATA has two power supply connectors you may use only one.
!
Otherwise damages may result.
Observe the vendors operating manual.
52
A26361-K666-Z120-1-7619, edition 3