Dns Settings - Dell Remote Console Switch User Manual

To configure IPv4 network settings:
1 Click the IPv4 tab to display the IPv4 Settings screen.
2 Click to fill or clear the Enable IPv4 checkbox.
3 Enter the desired information in the Address, Subnet, and Gateway fields.
IPv4 addresses are entered as the xxx.xxx.xxx.xxx dot notation.
4 Select either Enabled or Disabled from the DHCP drop-down menu.
NOTE: If you enable DHCP, any information that you enter in the Address,
Subnet, and Gateway fields will be ignored.
5 Click Save.
To configure IPv6 network settings:
1 Click the IPv6 tab to display the IPv6 Settings screen.
2 Click to fill or clear the Enable IPv6 checkbox.
3 Enter the desired information in the Address, Subnet, and Prefix Length
fields. IPv6 addresses are entered as the FD00:172:12:0:0:0:0:33 or
abbreviated FD00:172:12::33 hex notation.
4 Select either Enabled or Disabled from the DHCP drop-down menu
NOTE: If you enable DHCPv6, any information that you enter in the Address,
Gateway, and Prefix length fields will be ignored.
5 Click Save.
DNS Settings
You can choose to either manually assign the DNS server or to use the addresses
obtained using DHCP or DHCPv6.
To manually configure DNS settings:
1 From the side navigation bar, select DNS to display the RCS DNS Settings
screen.
2 Select Manual, DHCP (if IPv4 is enabled) or DHCPv6 (if IPv6 is enabled).
xxx |
56 Local and Remote Configuration
xxx