Appendix B: Using Sips; Acs Console Server Port Pinouts - Dell Remote Console Switch User Manual

Appendix B: Using SIPs

An administrator can choose between the Avocent ACS console server and
Cisco pinouts for each serial SIP port via the local user interface or the remote
OBWI. ACS is the default.
To change the pinout to Cisco mode:
1 Select Unit View - RCS - RCS Settings - Ports - SIPs.
2 Click on the desired SIP.
3 Select Settings - Pinout.
NOTE: If the DB-9 adaptor is used, select the ACS console server pinouts.

ACS Console Server Port Pinouts

The following table lists the ACS console server serial port pinouts for the SIP.
Table B.1: ACS Console Server Serial Port Pinouts
Pin No. Signal Name
1 RTS - Request to Send
2 DTR - Data Terminal Ready
3 TXD - Transmit Data
4 GND - Signal Ground
5 CTS - Clear to Send
Input/Output
OUT
OUT
OUT
N/A
IN
Appendix B: Using SIPs
B
xxx | xxx
157