Troubleshooting The Microprocessor - Dell PowerEdge 850 Installation And Troubleshooting Manual

Action
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Run the appropriate online diagnostic test. See
2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
3. Open the system. See "Opening the
4. Ensure that each expansion card is firmly seated in its connector. See
5. Close the system. See "Closing the
6. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
If the problem persists, go to the next step.
7. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
8. Open the system. See "Opening the
9. Remove all expansion cards installed in the system. See
10. Close the system. See "Closing the
11. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
12. Run the appropriate online diagnostic test.
If the tests fail, see "Getting
13. For each expansion card you removed in
a. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
b. Open the system. See
c. Reinstall one of the expansion cards. See
d. Close the system. See
e. Run the appropriate diagnostic test.
If the tests fail, see "Getting
Troubleshooting the Microprocessor
Problem
Error message indicates a processor problem.
l
Action
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Run the appropriate online diagnostics test. See
2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
3. Open the system. See "Opening the
4. Ensure that the processor and heat sink are properly installed. See "Processor" in "Installing System Components."
"Using Server Administrator
System."
System."
System."
"Removing an Expansion
System."
Help."
step 9, perform the following steps:
"Opening the System."
"Installing an Expansion
"Closing the System."
Help."
"Using Server Administrator
System."
Diagnostics" in "Running System Diagnostics."
"Installing an Expansion Card" in "Installing System Components."
Card" in "Installing System Components."
Card."
Diagnostics" in "Running the System Diagnostics."