11. Connect the power cable connector P3 to the power connector on the SCSI backplane. See Figure 7-13.
12. Connect the baseboard management controller (BMC) inter-IC (I2C) cable to the SCSI backplane. See Figure 7-13.
13. Connect the other end of the BMC I2C cable to connector BP_I2C on the system board. See Figure A-3.
14. Install the SCSI controller card.
See
"Installing an Expansion
15. Connect the SCSI data cable to the SCSI controller card, and to the SCSI interface connector on the backplane. See
16. Install the cover. See
"Replacing the
17. Stand the system upright.
18. Install the SCSI drives into the hard-drive bay.
See Figure 7-11.
19. Install the bezel. See
"Installing the
20. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
21. Install any required SCSI device drivers.
22. Run the SCSI controllers tests and the hard-drive tests in the system diagnostics. See
Installing a RAID Controller Card
See
"Installing an Expansion
Card" in "Installing System Components" for instructions about installing the card.
Back to Contents Page
Card" in "Installing System Components" for instructions about installing the card.
Cover" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."
Figure 7-12
"Running the System
Diagnostics."
and Figure 7-13.