Recommended Tools; Removing The Control Panel Assembly; Installing The Control Panel Assembly - Dell PowerEdge 850 Installation And Troubleshooting Manual

Back to Contents Page
Service-Only Parts Replacement Procedures
Dell™ PowerEdge™ 850 Systems Installation and Troubleshooting Guide
Recommended Tools
Control Panel Assembly
Daughter Card
System Board
Recommended Tools
You may need the following items to perform the procedures in this section:
Key to the system keylock
l
Wrist grounding strap
l
#2 Phillips screwdriver
l
Control Panel Assembly

Removing the Control Panel Assembly

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer and protecting against electrostatic discharge.
1. Open the system. See "Opening the
2. Disconnect the control panel cables. See Figure 7-1.
3. Using a #2 Phillips screwdriver, remove the two screws that secure the control panel assembly to the chassis. See Figure 7-1.
4. Carefully lift the back of the control panel assembly to clear the chassis mounting studs, and remove the assembly from the system.
Figure 7-1. Removing the Control Panel Assembly

Installing the Control Panel Assembly

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.
Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the
computer and protecting against electrostatic discharge.
System" in "Troubleshooting Your System."