Dell PowerEdge 850 Installation And Troubleshooting Manual page 67

Removing a Front-Access SCSI Hard Drive (Non-Hot-Plug)
NOTICE: To prevent data loss, you must shut down the system before removing a SCSI drive carrier, unless a SCSI RAID controller is connected to the
SCSI backplane. See "Hot-Plug SCSI Hard
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the
3. Open the hard-drive carrier handle to release the drive. See Figure 7-11.
4. Slide the hard drive out until it is free of the drive bay.
Figure 7-11. Removing or Installing a SCSI Hard-Drive Carrier
Installing a Front-Access SCSI Hard Drive (Non-Hot-Plug)
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the
3. Open the hard-drive carrier handle. See Figure 7-11.
NOTICE: Do not insert a hard-drive carrier and attempt to lock its handle next to a partially installed carrier. Doing so can damage the partially installed
carrier's shield spring and make it unusable. Ensure that the adjacent drive carrier is fully installed.
4. Insert the hard-drive carrier into the drive bay. See Figure 7-11.
5. Close the hard-drive carrier handle to lock it in place.
Drives" for information on hot-plug drive requirements and operation.
Bezel" in "Troubleshooting Your System."
Bezel" in "Troubleshooting Your System."