Output Sel Screen - Panasonic AG-HPX301E Operating Instructions Manual

Item
R.MIC POWER Turns on and off the phantom power supply for the
rear microphone.
ON: Turns on the phantom power supply to the
microphone when the rear LINE/MIC/+48V switch is
set to +48V.
OFF: Does not supply phantom power to the
microphone even when the rear LINE/MIC/+48V switch
is set to +48V.
MONITOR SELECT Switches the output signal to AUDIO OUT, earphones
and speaker when the MONITOR SELECT switch is
set to ST.
STEREO, MIX
F.MIC LEVEL Selects the input level for the front microphone.
–40dB, –50dB, –60dB
R.MIC CH1 LEVEL Selects the input level for the rear microphone
connected to CH1.
–50dB, –60dB
R.MIC CH2 LEVEL Selects the input level for the rear microphone
connected to CH2.
–50dB, –60dB
HEADROOM Sets the headroom (standard level).
18dB, 20dB
WIRELESS WARN Sets whether a warning should be output when
wireless receiver reception is poor.
ON, OFF
WIRELESS TYPE Selects wireless receiver type.
SINGLE: 1-channel receiver
DUAL: 2-channel receiver
• W hen DUAL is selected for a 1-channel wireless
receiver, CH2 and CH4 will stay mute.
1394 AUDIO OUT Selects audio channel output to 1394 OUT in DVCPRO
or DV mode.
CH1/CH2, CH3/CH4

OUTPUT SEL screen

Item
SDI SELECT Sets the signal format type output from the SDI OUT
connector.
AUTO: Depends on SYSTEM MODE setting.
1080i
SYSTEM MODE setting is 720-50P (720-59.94P).
576i (480i): Output is locked to 576-50i (480-59.94i)
regardless of SYSTEM MODE setting.
SDI METADATA Sets metadata (UMID) superimposition onto SDI OUT.
ON: Superimposes metadata.
OFF: Does not superimpose metadata.
SDI EDH Sets EDH superimposition when SDI OUT is an SD
signal (576i (480i)).
ON: Superimposes EDH.
OFF: Does not superimpose EDH.
DOWNCON MODE Sets downconverter output (VIDEO OUT and 576i
(480i) SDI OUT) in HD mode (1080i, 720P).
SIDE CROP, LETTER BOX, SQUEEZE
*1 Use 1080i selected in a SYSTEM MODE setting of 720-50P (720-59.94P) for checking video.
Setting
Setting
: Outputs 1080-50i (1080-59.94i) also when
*1
Notes
• A vailable only when SYSTEM MODE
is set to 576-50i (480-59.94i) and REC
FORMAT is set to DVCPRO or DV.
Notes
• N ot available when SYSTEM MODE is
set to 576-50i (480-59.94i). Then 576i
(480i) is output at all times.
• N ot available when SYSTEM MODE is
set to 576-50i (480-59.94i).
____ indicates the factory setting
1