Panasonic AG-HPX301E Operating Instructions Manual page 136

Item
MIC LOWCUT CH1 Sets the CH1 microphone low-cut filter.
*1
FRONT: Operates for the front microphone input.
W.L.: Operates for wireless receiver input.
REAR: Operates for the rear microphone input.
OFF: Turns off the filter for all inputs.
MIC LOWCUT CH2 Sets the CH2 microphone low-cut filter.
*1
Same setting as MIC LOWCUT CH1.
OFF (factory default setting)
MIC LOWCUT CH3 Sets the CH3 microphone low-cut filter.
*1
Same setting as MIC LOWCUT CH1.
OFF (factory default setting)
MIC LOWCUT CH4 Sets the CH4 microphone low-cut filter.
*1
Same setting as MIC LOWCUT CH1.
OFF (factory default setting)
LIMITER CH1 Sets the CH1 limiter.
ON, OFF
LIMITER CH2 Sets the CH2 limiter.
ON, OFF
AUTO LEVEL CH3 Selects the method for setting CH3 level.
ON: Engages the auto adjustment mode. The limiter is
not available.
OFF: Locks the level. The limiter operates on all inputs
except the line input of the rear.
AUTO LEVEL CH4 Selects the method for setting CH4 level.
Same setting as AUTO LEVEL CH3.
ON (factory default setting)
25M REC CH SEL Selects the audio channels to be recorded in the
DVCPRO and DV formats.
2CH: Only recorded on CH1 and CH2.
4CH: Records on all four channels.
TEST TONE Selects the test signal.
NORMAL: Outputs test tones to channels 1, 2, 3 and
4 when the OUTPUT/AUTO KNEE selector switch is
set to BARS and the AUDIO IN switch CH1 is set to
FRONT.
ALWAYS: Outputs test tones to channels 1, 2, 3 and
4 at all times when the OUTPUT/AUTO KNEE selector
switch is set to BARS.
CHSEL: Outputs test tones to channels selected by
setting the AUDIO IN switch CH1 or CH2 to FRONT
and the OUTPUT/AUTO KNEE selector switch is set to
BARS. (Test tones are not output to CH3 and CH4.)
OFF: Does not output a test tone.
F.MIC POWER Turns on and off the phantom power supply for the
front microphone.
ON, OFF
*1 The frequency characteristics for a microphone low-cut filter is 200 Hz – 10 kHz.
1
Setting Notes
• W hen the AUDIO SELECT CH1 switch
is set to AUTO and auto adjustment
mode is active, the limiter is disabled
regardless of these settings.
• W hen the AUDIO SELECT CH2 switch
is set to AUTO and auto adjustment
mode is active, the limiter is disabled
regardless of these settings.
• N ot available in the following
conditions.
- W hen SYSTEM MODE is 1080-50i
(1080-59.94i) or 720-50P (720-
59.94P).
- W hen SYSTEM MODE is set to 576-
50i (480-59.94i) and REC FORMAT is
set to the DVCPRO50 codec.
- R EC SIGNAL is set to 1394
(operation depends on 1394 input
status).
____ indicates the factory setting