Panasonic AG-HPX301E Operating Instructions Manual page 160

Item Message
CANNOT ACCESS
CARD!
CANNOT ACCESS
TARGET!
CANNOT FORMAT!
CANNOT RECOGNIZE
HDD!
CARD IS EMPTY!
CANNOT COPY!
HDD CAPACITY FULL! Not enough space left on the hard disk.
HDD DISCONNECTED! The unit is not connected to a hard disk.
HDD
(USB
MISMATCH
HOST
COMPONENT!
MODE)
P2 CARD IS
UNFORMATTED!
PLEASE FORMAT P2
CARD!
TOO MANY
PARTITIONS!
TOO MANY TARGETS! Multiple devices are connected.
UNKNOWN DEVICE
CONNECTED!
VERIFICATION FAILED! The compare check after copying failed.
10
Description
An error occurred during P2 card access.
An error occurred during hard disk access.
The hard disk cannot be initialized.
The destination target cannot be properly
recognized.
The P2 selected for copying is empty.
Copying cannot be made because the
destination card is in the wrong format.
The P2 card is not formatted.
This warning indicates that data could not
be imported from a hard disk to a P2 card
because the P2 card contained recorded
data.
There are too many partitions.
The connected DVD drive is not compatible.
(Continued from the previous page)
Measure
Check P2 card.
Check hard disk status and connection.
Connect another hard disk drive.
Reboot the hard disk or connect a different
hard disk.
Copying is not performed since the card
is empty.
There is not enough space on the
connected hard disk. Use a new hard disk
or formatted hard disk.
Reconnect the USB cable. If the hard disk
does not operate normally, turn it off and
turn it back on again.
Use a P2 card with the same model
number or import video in clip units.
Use a formatted P2 card.
You cannot copy to a P2 card that
contains data. Format the card on a P2
device and copy again.
Hard disks can handle up to 23 partitions.
Use a new hard disk or formatted hard
disk.
Disconnect devices, turn off the unit and
turn it back on again.
Disconnect devices, turn off the unit and
turn it back on again.
Copy the data again.