Panasonic AG-HPX301E Operating Instructions Manual page 158

Warning LCD or viewfinder
Priority
type indication
1394
1394 INITIAL ERROR Blinks
8 connection
red
error
The last bar in the battery
level indication blinks (This
Battery
9 indication appears also
nearly empty
when MENU indications
have been turned OFF.)
P2 card
The P2CARD level indicator
10 nearly fully
blinks.
recorded
*1 P2 SYSTEM ERROR cause indication
• P 2 MICON ERROR: The P2 microprocessor does not respond.
• P 2 CONTROL ERROR: A P2 recording control error has occurred.
• C AM MICON ERROR: The camera microprocessor does not respond.
*2 REC WARNING cause indication
• C ARD ERROR*: P2CARD error (* indicates the number of the slot of the card with the error.) Stops recording.
• R EC RAM OVERFLOW: Overflow of recording RAM. Stops recording.
• P ULL DOWN ERROR: 25P (30P, 24P) video pulldown error. Recording continues.
• E RROR: Other recording errors (When an attempt is made to record 1000 or more clips on one P2 card.)
*3 Perform either of the following procedures to cancel this warning.
• P ress a playback control button.
• P ress the THUMBNAIL button.
• R emove the P2 card and insert another card.
*4 Perform either of the following procedures to cancel this warning.
• P ress the REC button.
• P ress a playback control button.
• P ress the THUMBNAIL button.
• R emove all cards.
*5 W hen NEAR END CANCEL is set to ON, you can press the DISP/MODE CHK button to cancel the alarm.
*6 W hen the alarm sounds, audio is not output to the camera speakers or earphones. The DISP/MODE CHK button cancels
only the alarm tone when pressed during an alarm.
1
Warning Alarm
Tally lamp
lamp tone
Blinks 4 Blinks 4
times per times per No
second second
Blinks 1 time Blinks 1 time
No
per second per second
Blinks 1 time Blinks 1 time
per second per second
No
during during
recording. recording.
(Continued from the previous page)
Warning description
and recording/playback
*6
operation
The DVCPRO/DV cable
has become disconnected
or multiple devices are
connected.
The battery is near depletion.
Operation continues.
*5
Less than 2 minutes is left on
the P2 cards (level indicator
shows 1 minute or less). This
warning appears only during
recording.
Countermeasures
Check the camera
and device
connections,
reconnect them if
necessary, then turn
the power off and
back on again.
Replace the battery
as necessary.
Replace or insert
additional P2 cards.