Rackmount Wiring Installation; Installing The Ups - Eaton 9130 User Manual

M6 Cage Nuts
(4 places)
Figure 7. Securing the Front of the Cabinet
13. Optional. Insert a rear stop bracket through the inside of each rail behind the UPS. Rotate each bracket
and slide the bracket until it fits tightly against the UPS's rear panel. Secure each bracket to the UPS with
one M3x8 pan-head screw. See Figure 8.
Repeat for any optional cabinets.
14. Continue to the following section, "Rackmount Wiring Installation. "
e R r a
Figure 8. Securing the Back of the Cabinet (Optional)

Rackmount Wiring Installation

This section explains:
Installing the UPS, including connecting the UPS internal batteries
l
Connecting any optional EBMs
l

Installing the UPS

To install the UPS:
1. Remove the UPS right front cover (behind the LCD control panel). See Figure 9.
To remove the cover, remove and retain the two screws on the right side of the cover. Grasp the top and
bottom of the cover and slide the cover to the right.
t S p o B a r k c t e
NOTE 1 Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
NOTE 2 Do not connect the UPS power cord to utility until after installation is completed.
Eaton 9130 700/3000 VA UPS User's Guide 164201718—Rev 7 www.eaton.com/powerquality
M6 16 Pan-Head
Screws (4 places)
M 3 8 Pan-Head Screw
Installation
16