Ups Shutdown; Transferring The Ups Between Modes; Retrieving The Event Log; Logic Power Off - Eaton 9130 User Manual

To start the UPS on battery:
1. Press the
status of "UPS starting
The UPS cycles through Standby mode to Battery mode. The
supplies power to your equipment.
2. Check the UPS front panel display for active alarms or notices besides the "UPS on Battery" notice and
notices that indicate missing utility power. Resolve any active alarms before continuing. See
"Troubleshooting" on page 83.
Check the UPS status from the front panel to view the active alarms. Correct the alarms and restart if
necessary.
3. Press the

UPS Shutdown

To shut down the UPS:
1. Press the
The UPS starts to beep and shows a status of "UPS off pending..." . The UPS then transfers to Standby
mode, and the
2. Switch off utility power where the UPS is connected.

Transferring the UPS Between Modes

From Normal to Bypass Mode. Press any button to activate the menu options, then select CONTROL and
GO TO BYPASS.
From Bypass to Normal Mode. Press any button to activate the menu options, then select CONTROL and
GO TO NORMAL.

Retrieving the Event Log

To retrieve the Event Log through the display:
1. Press any button to activate the menu options, then select EVENT LOG.
2. Scroll through the listed events.

Logic Power Off

If normal utility power is restored within the time set by the Logic Power Off parameter, the unit restarts
automatically. If AC power is not restored within this time, the logic power turns off.
button on the UPS front panel until the UPS front panel display illuminates and shows a
" .
...
button until the start screen appears.
ESC
button on the front panel for three seconds.
indicator turns off.
NOTE Releasing the
operating mode.
NOTE The equipment does not restart automatically when normal utility power is restored
if the unit is shut down by power shutdown management software or a connectivity
card, such as the Intelligent Power
Eaton 9130 700/3000 VA UPS User's Guide 164201718—Rev 7 www.eaton.com/powerquality
button before three seconds returns the UPS to its original
Protector (IPP) or a Network Card-MS.
®
indicator illuminates solid. The UPS
Operation
33