Changing The Language; Display Functions - Eaton 9130 User Manual

Changing the Language

Press and hold the first button on the left for approximately three seconds to select the language menu. This
action is possible from any LCD menu screen.

Display Functions

As the default or after 15 minutes of inactivity, the LCD displays the start screen.
The backlit LCD automatically dims after 15 minutes of inactivity. Press any button to restore the screen.
Press any button to activate the menu options. Use the two middle buttons ( and ) to scroll through the menu
structure. Press the Enter (
previous menu.
Table 2 shows the basic menu structure.
Table 2. Menu Map for Display Functions
Main Menu Submenu
UPS Status
Event Log
Measurements
Control Go to Bypass
Start Battery Test
Reset Error State
Load Segments
Restore Factory Settings
Identification
Settings User Settings
Service Settings
) button to select an option. Press the
(
Display Information or Menu Function
Main status (mode and load) / Notice or Alarm status (if any) / Battery
status (state and charge level)
Displays up to 127 events and alarms
The Event Log is also available through the serial port. See "Retrieving the
Event Log"on page 33.
Load W VA / Load A pf / Output V Hz / Input V Hz / Bypass V Hz / Input Line
Events / Battery V min
Transfers the UPS system to internal Bypass mode
When this command is active, the option changes to "Go to Normal."
Starts a manual battery test
See "Testing New Batteries"on page 52.
Clears a "Battery Test Failed"alarm
Load segment 1: ON | OFF
Load segment 2: ON | OFF
These commands overrule user settings for load segments. See
"Configuring Load Segments"on page 35.
Returns all settings to original values only after UPS is powered down.
The following settings do not change:
"Output voltage setting
"Site wiring fault alarm
"REPO terminal setting
"Serial number
"Part number
UPS Type / Part Number / Serial Number / Firmware
See Table 3 for details.
This menu is password-protected.
Eaton 9130 700/3000 VA UPS User's Guide 164201718—Rev 7 www.eaton.com/powerquality
button to cancel or return to the
ESC
Operation
27