Adjusting The Height Of The Armrest For Desk Side Panel; Adjusting The Seat Depth - Otto Bock M1 Intro Instructions For Use Manual

Turn the release lever until it hits the stop. While propping up the footrest bar, set the desired
angle. Then carefully let the release lever turn back. At the next free position, the footrest will
snap into place.

6.9 Adjusting the height of the armrest for desk side panel

The armrest can be set to three different heights. In the standard assembly, the armrest is
mounted firmly onto the tube bend.
INFORMATION!
To increase the armrest height, remove the two cap screws completely from the
tube bend. Then place the two distance pieces above the tube bend between
armrest and side panel tube to adjust a further height.
INFORMATION!
Make sure to firmly retighten all screws and nuts after making adjustments.

6.10 Adjusting the seat depth

Undo the hook-and-loop attachment between back padding and seat upholstery.
Loosen the screw connections A that connect the rear wheel adapter to the open frame tube.
Remove the screws. The rear wheel adapter can then be shifted along the frame tube. Three
different seat depth adjustments, in 3 cm increments, are possible.
30
(Fig. 31)
(Fig. 30)
57