Table of Contents
Advertisement
Ⅵ. TROUBLE SHOOTING
1. You must turn off the power switch before installation of this equipment
2. Avoid installation places where it is the ultimate cold, hot, and humid.
3. Use a power supply of AC24V, 1.5A output.
4. Please be careful that you connect respective wires without mismatching in installation.
5. Check the controlled cable's insulation connecting to exterior and supply to power sources.
6. Please keep the equipment from impact and strong rolling in installation or in use because of the
caution of troubles.
TROUBLE SHOOTING
Power do not turn on
Power turned on but do not operate.
The acting of pan/tilt is not good.
Either it is not clean on screen or it is
appeared rolling TV lines on screen.
It is not focus on the object by
manual.
It is continuously appeared error
message
of
"
P/T POSITION
ERROR"
It is continuously appeared error
message
of
"
SORRY
MEMORY"
It does not alarm relay ON in active
alarm state.
Even if sensor is normal, it is
activated abnormal.
CHECK POINT
Does the electric power supply into
the equipment normally?
In operating, Does the LED beside
power switch light to red?
Did you select to RS485 or RS422
exactly?
Did you turn on the ending terminal
register? (The ending terminal
resister can be switch on/off, if you
loose cover of dome.)
Is the power supply AC24V, 1.5A
output?
Did you change min. distance in the
set menu?
Did the under body of camera press
or put between others?
Did you set the related function?
NOT
Did you set ON the alarm relay in
the set mode?
Is it correct alarm active setting
status and sensor is either open or
close?
Check either LED is lit or not in the
connector part of back box.
Check the connecting status of
data cable, if it is not lit.
If it is lit, check address and
communication speed setting of
DIP switches.
Check the status at number 2 of option
DIP switches.
Switch on the ending terminal resister
of camera to be set in most far away.
Change the adapter has higher current
charge than used adapter.
Change min. distance in the set menu.
Get rid of something that press
camera, and check either camera is
rotating in softly or not.
Please refer to manual book and
setting the function you want
Please select on to enable alarm relay
in the set mode
Please set alarm active mode setting
as to correct to connect status of
sensor (it means either sensor is open
or close) in the set mode.
33
MAINTENANCE
Advertisement
Table of Contents
