Table of Contents
Advertisement
Antenna Tube Installation
1. Install the short tube (A) over the grommet (B)
on the hull (C).
2. Feed the antenna wire (D) of the receiver
through the grommet and into the antenna
tube (E).
3. Install the antenna tube in the grommet and the
cap (F) on the tube.
Decal Application
Included decals are intended for display purposes only.
Ensure the boat hull is clean. Lift a decal from a sheet
and carefully apply it to the boat as you desire. National
flag decals may be folded in half around the flag post on
the rear of the boat. A triangular flag may be folded in
half around the short flag post in front of the windshield.
Scale features
For display purposes, the steering wheel or other scale
features may be installed on the boat.
Boat Battery Installation
1. Apply the included hook and loop tape to the battery.
Do not cover the battery warning label.
Tip: Clean the battery pack with motor spray or rubbing
alcohol and a clean cloth before installing hook and loop
tape so adhesive can stick better.
2. Remove the front seat hatch and the rear deck hatch
from the boat.
3. In the rear hatch opening, install the battery connector
in the boat hull with the connector facing the front of
the boat.
1
Transmitter Battery Installation
Volere 22
The antenna must be installed correctly above
the boat's water line to get the best reception of
your transmitter's signal.
Tip: Secure the antenna wire inside the hull
and the tube in the grommet using tape to
prevent loss in windy conditions.
4. Install the battery in the left side of the hull with the 2
horizontally-mounted battery cells facing the outside
of the hull.
5. Center the battery over the hook and loop tape in the
hull, then push the battery down a small amount to
secure it.
6. Refer to Getting Started instructions to power on your
boat. Install the hatches on the boat before operation
in water.
Tip: If desired, apply waterproof tape over the hatch edge
to help keep water out of the hull.
IMpORTANT: Always remove the battery from the boat
for transport and storage.
2
This transmitter requires 4 AA batteries.
1. Remove the battery cover from
2. Install the batteries as shown.
3. Install the battery cover.
3
the transmitter.
EN
F
E
C
A
D
B
5
Advertisement
Table of Contents
