Table of Contents
Advertisement
Quick Links
®
29-inch Brushless-Powered Catamaran
Owners Manual
PRB4075 (PNP) and PRB4075S (RTR)
Specifications
Length .......................................................................................... 30 in (762mm)
Beam ............................................................................................ 11 in (279mm)
Motor ...........................................................A3630-1800Kv Water-Cooled Brushless
Receiver ............................ Spektrum 2.4GHz Marine (not included with PNP version)
Speed Control ............................................................ 60-amp Waterproof Brushless
Hull Material .......................................................................... Fiberglass Composite
Battery ...... 7.4V 2S 30C Li-Po or 7.2V Sub-C with Deans Connector (2) (not included)
Radio .......................................................2-channel (not included with PNP version)
www.ProBoatModels.com
Advertisement
Table of Contents
Related Manuals for ProBoat PRB4075
Summary of Contents for ProBoat PRB4075
- Page 1 ® 29-inch Brushless-Powered Catamaran Owners Manual PRB4075 (PNP) and PRB4075S (RTR) Specifications Length ..................30 in (762mm) Beam .................... 11 in (279mm) Motor ............A3630-1800Kv Water-Cooled Brushless Receiver ......Spektrum 2.4GHz Marine (not included with PNP version) Speed Control ............60-amp Waterproof Brushless Hull Material ................
-
Page 2: Table Of Contents
Notice All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit http://www. horizonhobby.com and click on the support tab for this product. Meaning of Special Language The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property... -
Page 3: Recommended Tools And Adhesives
Recommended Tools and Adhesives • Needle nose pliers • Phillips screwdriver: #1 • Marine grease (PRB0100 or PRB0101) • Hex wrench: 2.5mm, 3mm • Paper towel • Clear tape (PRB0102) • Rubbing alcohol • Hook and loop tape • Open end wrench: 7mm, 10mm Recommended Batteries Batteries We recommend the purchase of two of the following batteries (Model requires two batteries to... -
Page 4: Assembly
Assembly Required Equipment and Accessories 3. Install the four AA batteries in the battery holder. Match the polarity of the Transmitter batteries to the molded markings in the AA battery (4) Motor battery (2) (charged) battery holder. Hook and loop tape 1. -
Page 5: Receiver And Speed Control Installation
Receiver and Speed Control Installation Required Equipment and Accessories 3. Use hook and loop tape to secure the receiver in the hull. The lead from the Hull assembly Receiver steering servo plugs into the STR port, and Speed control Antenna tube Hook and loop tape the speed control plugs into the THR port. -
Page 6: Battery Installation
Battery Installation Required Equipment and Accessories Note: Center the trims for both the steering and throttle on your transmitter Transmitter before turning the transmitter on. AA battery (4) Motor battery (2) (charged) 3. Move the switch on the transmitter to ... -
Page 7: Binding Procedure - Pnp Version Only
Binding Procedure - PNP Version Only (Applicable to all Spektrum DSM 2.4GHz marine compatible transmitters) Required Parts 3. Remember to remove the BIND plug from the receiver BEFORE turning off the Fuselage assembly radio system. Once you have completed Transmitter Bind plug binding the transmitter and receiver,... - Page 8 4. Turn on the transmitter, then the ESC 5. Check the operation of the steering in on/off switch. The ESC will beep until you relationship to the steering wheel. When pull the throttle trigger to full throttle and the wheel is rotated clockwise, the rudder return it to the neutral position.
-
Page 9: Handling Adjustments
Handling Adjustments Required Equipment and Accessories Raising the drive helps eliminate oscillation or bouncing and assist with top end stability but Hex wrench: 3mm excessively raising the drive can reduce top Open-end wrench: 7mm speeds and cause cavitation. Changing the Center of Gravity Moving the batteries to the front or back can significantly affect the boat's performance. -
Page 10: Maintenance
Maintenance Required Tools and Lubricants 3. Use a paper towel and rubbing alcohol to clean the flex shaft. Marine grease Paper towel Rubbing alcohol Open-end wrench: 10mm (2) Hex wrench: 2.5mm Nut driver: 4mm Lubricating the Flex Shaft Lubricating the drive system is vital to the life of the drivetrain. -
Page 11: Limited Warranty
Limited Warranty What this Warranty Covers nor accepted for any resulting damage or injury. By the act of use, setup or assembly, the user accepts Horizon Hobby, Inc. (“Horizon”) warrants to the all resulting liability. If you as the purchaser or user original purchaser that the product purchased (the are not prepared to accept the liability associated "Product") will be free from defects in materials and... -
Page 12: Warranty And Service Contact Information
original sales receipt must be included for warranty Non-Warranty Service consideration. Be sure your name, address, and RMA Should your service not be covered by number are clearly written on the outside of the warranty service will be completed and shipping carton. -
Page 13: Regulatory Information
Regulatory Information FCC Information (RTR Version) Antenna Separation Distance (RTR Version) This device complies with part 15 of the FCC When operating your transmitter, please be rules. Operation is subject to the following sure to maintain a separation distance of at least 5 cm between your body (excluding two conditions: (1) This device may not fingers, hands, wrists, ankles and feet) -
Page 14: Regulatory Information
No. HH2011052902 Declaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2011052901 Product(s): Mystic Catamaran 29 BL PNP Item Number(s): PRB4075 Product(s): Mystic Catamaran 29 BL RTR Equipment class: Item Number(s): PRB4075S The object of declaration described above is Equipment class:... -
Page 15: Item Identification
Item Identification Cooling Line Rudder Linkage Steering Servo Receiver Switch Rudder Motor Stuffing Box Speed Control Propeller Antenna Hull Hatch Cover Water Outlet Radio Box Stand Cover * Decals not shown for clarity Replacement Parts Go to ProBoatModels.com to see photos of the replacement parts listed under Mystic 29 BL. If you have any questions concerning the setup or running of your model, please see pages 12 to contact the appropriate Horizon service center. - Page 16 ® Mystic is a trademark of mystic Powerboats Inc. and is used with permission by Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Pro Boat, DSM2 and DSMX are trademarks or registered trademarks of Horizon Hobby, Inc. JR is a trademark of Horizon Hobby, Inc., registered in the U.S.
Need help?
Do you have a question about the PRB4075 and is the answer not in the manual?
Questions and answers