Section 1: Building the Boat Stand Section 3: Removing the Canopy Parts Required Unscrew.the.2.knurled.hatch-mounting.screws.from. Plywood.boat.stand.pieces.(4) the.rear.of.the.hatch..Lift.the.hatch.from.the.boat. Tools.and.adhesives.needed.for.completion CA.or.epoxy m.1..Attach.the.side.boat.pieces.by.interlocking. them.into.the.end.pieces.as.shown. m.2..Secure.the.interlocking.boat.stand.with. medium-thick.CA.or.epoxy..Make.certain.you. allow.the.CA.or.epoxy.to.fully.cure.before. placing.the.boat.on.the.stand. Section 4: Installing the Radio System Batteries Tools and Accessories Required 12.AA.batteries 2.5mm.hex.wrench Section 2: Attaching the Turn Fin Receiver Batteries m.1..Remove.the.2.5mm.hex.head.screws.that.
Section 14: Clutch Section 15: Troubleshooting Guide Problem Possible Solution Engine will not start Improper needle setting: See Zenoah ® engine manual Out of fuel: Fill fuel tank Improper fuel: Use fresh gasoline & Zenoah 2-cycle oil (mixed 32 parts gas to 1 part oil) Bad spark plug: Replace spark plug Flooded engine: Remove spark plug, invert boat and operate the pull-starter to remove fuel Engine starts, then dies Fuel line blocked or broken: Connect or replace fuel line Reset needles to baseline setting: See Zenoah instructions Baseline settings for low-speed and hi-speed needle valves is 1–1 turns out The.centrifugal.clutch.automatically.engages.when. the.engine.rpm.is.increased..Be.sure.that.the.idle. Engine starts and runs for Bad fuel: Replace several minutes, then dies Improper needle settings: See Zenoah engine manual speed.adjustment.is.set.low.enough.so.that.the. Overheated engine: Check for clogged or damaged cooling system propeller.does.not.rotate.at.idle. Debris in carburetor: Remove, clean and replace Section 16: Hull Care The.hull.of.the.Miss.Elam.is.finished.using.the.highest-quality.paints.and.the.most.advanced.painting.methods. Periodically.disassemble.the.clutch.and.clean.debris. available..The.base.coat/clear.cote.technique.delivers.an.amazing.shine.that.is.as.durable.as..