Table of Contents
Advertisement
EN
Boat will not Bind
(during binding) to
transmitter
Boat will not connect
(after binding) to
transmitter
Boat tends to dive in
the water or takes on
water
Boat tends to turn one
direction
Rudder does not move
Controls reversed
Motor overheats
Motor power pulses
then motor loses power
12
Transmitter is too near boat during
binding process
Boat or transmitter is too close to
large metal object, wireless source
or another transmitter
Boat battery/Transmitter battery charge
is too low
Another compatible transmitter is
powered on within range of the ESC
ESC switch is off
Transmitter is too near boat during
connecting process
Boat or transmitter is too close to
large metal object, wireless source
or another transmitter
Boat battery/transmitter battery charge
is too low
ESC switch is off
The boat hull is not completely closed
Center of gravity is incorrect
Rudder or rudder trim is not centered
Rudder, linkage or servo damage
Wire is damaged or connections are
loose
Transmitter is not bound correctly
BEC (Battery Elimination Circuit) of the
ESC is damaged
ESC switch is off
Transmitter settings are reversed
Blocked water cooler tubes
ESC uses default soft Low Voltage Cut-
off (LVC)
Weather conditions might be too cold
Battery is old, worn out or damaged
Battery C rating might be too small
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Move boat and transmitter to another location
and attempt binding again
Replace/recharge batteries
Turn off all compatible transmitters except
the one you are trying to bind
Power on ESC switch
Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Move boat and transmitter to another location
and attempt connecting again
Replace/recharge batteries
Power on ESC switch
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Move the battery in the hull
Repair rudder or adjust rudder and rudder trim
for straight running when control is at neutral
Replace or repair damaged parts and adjust con-
trols
Do a check of wires and connections, connect
or replace as needed
Re-bind receiver to the transmitter
Replace ESC
Power on ESC switch
Do the Control Direction Test and adjust controls
on transmitter appropriately
Clean or replace water tubes
Recharge boat battery or replace battery that is
no longer performing
Postpone until weather is warmer
Replace battery
Use recommended battery
Volere 22
Advertisement
Table of Contents
