Battery Charger; Antenna Tube Installation; Getting Started - ProBoat Miss GEICO 17 Owner's Manual

Battery Charger

1. Connect the battery pack to the charger.
2. Connect the charger to an AC power source.
3. Allow the battery pack to charge for 12 hours.

Antenna Tube Installation

1. Carefully feed the end of the receiver antenna
through the grommet inside the hull.
2. Pull the antenna wire out of the grommet
towards the outside of the boat, then slide the
antenna through the antenna tube.

Getting Started

1. Power on the transmitter.
2. Connect the battery.
3. Power on the ESC switch.
1
4
2.4GHZ DIGITAL
RADIO SYSTEM
INSTRUCTION MANUAL
3. Insert the tube into the grommet, then fit the cap
4. Apply clear tape to the antenna, grommet and hull
The outer end of the antenna must be installed above
the waterline of the boat to get the best reception
of your transmitter's signal.
4. Test the transmitter's control of
the boat with the boat on the
display stand.
2
5
CAUTION: If at any time during the charge
process the battery pack(s) becomes hot to the touch,
unplug the battery immediately and discontinue the
charge process.
onto the tube.
of the boat to keep the antenna from moving.
5. After launching the boat in the
water, start driving slowly. If the
boat does not go straight, adjust
the steering trim dial on the
transmitter.
3
EN
5