Checklists; Before Boating; After Boating; Troubleshooting Guide - ProBoat Volere 22 Owner's Manual

Pro boat volere 22 rc model boat (prb3050b/ prb3050bi)
Hide thumbs Also See for Volere 22:
Table of Contents

Advertisement

Checklists

Before Boating

• Install fully charged batteries in your boat and new AA
batteries in your transmitter
• Connect the boat's battery to the ESC
• Make sure the boat is bound to the transmitter
(otherwise, bind the boat to the transmitter using
the included binding instructions)
• Make sure all linkages move freely on the boat
• Ensure the motor mount is secured to the hull so that
the motor does not move
• Perform a Control Direction Test with the transmitter
• Adjust the steering rate on your transmitter as desired
• Find a safe and open area of operation
• Plan a safe route for the water and wind conditions

Troubleshooting guide

problem
Boat will not respond
to throttle but responds
to other controls
Extra noise or extra
vibration
Reduced runtime or
boat underpowered
Volere 22
possible Cause
Throttle servo travel is lower than 100% Make sure throttle servo travel is 100% or greater
Throttle channel is reversed
Damaged propeller, shaft or motor
Propeller is out of balance
Boat battery charge is low
Boat battery is damaged
Blocking or friction on shaft or propeller
Boat conditions may be too cold
Battery capacity may be too low
for conditions
Too little lubrication on driveshaft
Vegetation or other obstacles block
the rudder or propeller

After Boating

• Always power off the receiver before powering off
the transmitter to maintain control of the boat and
to retain transmitter binding
• Disconnect the battery from the receiver and remove
the batteries from the boat
• Fully dry the inside and outside of the boat, including
the water cooling lines and coil around the motor.
Remove the hatch before storing your boat.
• Repair any damage or wear to the boat
• Lubricate the driveshaft
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions
Tip: The hook and loop strips in the boat retain water.
To dry them, press on them with a dry cloth. Use a
sponge, paper towel or cloth to remove water from
inside the hull.
NOTICE: When you are finished boating, never keep
the boat in the sun. Do not store the boat in a hot,
enclosed area such as a car. Doing so can damage the
boat.
Solution
Reverse throttle channel on transmitter
Replace damaged parts
Balance or replace propeller
Completely recharge battery
Replace boat battery and follow
battery instructions
Disassemble, lubricate and correctly align parts
Make sure battery is warm before use
Replace battery or use a larger capacity battery
Fully lubricate driveshaft
Remove boat from the water and obstacles
EN
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prb3050bPrb3050bi

Table of Contents