Table of Contents
Advertisement
Introduction
®
Pro Boat
RC models look as good as they perform. Our boats, which include everything from scale sailboats to
fully licensed powerboats, exceed expectations and provide years of radio control fun and excitement. Whether your
passion leads you towards the pure serenity of sailing or the all-out speed of a Deep-V, Pro Boat models fit your taste,
budget and lifestyle. You can count on us to be available any time you need help—the brand is backed by Horizon
Hobby, one of the world's largest distributors of hobby-grade RC products. The Pro Boat brand will help you turn your
boating passion into a reality, whether you're new to the hobby or an old pro.
Please read this manual for operation and maintenance instructions.
Register your boat online at www.proboatmodels.com.
Recommended Tools and Materials
• Paper towel
• Rubbing alcohol
• Medium threadlock
• Household light machine oil
• Motor spray (DYN5500)
• 2.5mm ball type hex wrench
• Small Flat Blade Screwdriver
• Fine sandpaper or Emery cloth
• Clear tape (PRB0102)
• Pro Boat® Marine Grease and Gun (PRB0100)
• Medium CA (cyanoacrylate adhesive) or epoxy
adhesive
Specifications
length
22.0 in (559mm)
Beam
7.5 in (191mm)
(width)
5.0 in (127mm)
Hull height
Boat Stand Assembling
1. Insert the tabs of the side stand pieces in the slots
in the end pieces. The lettering on the side pieces
should face out from the sides of the stand.
2. While the stand is level on a flat surface, apply
medium CA or epoxy adhesive to secure the side
stand pieces to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.
Volere 22
product Inspection
Carefully remove the boat and radio transmitter from the
box. Inspect the boat for damage. If you find damage
is present, please contact the hobby shop where you
purchased your boat.
Contents
Transmitter 2.4GHz Pistol Grip
Receiver
2-channel 2.4GHz
Hull Material
ABS Plastic
Motor
550 Brushed Motor,
water-cooled
ESC
Electronic speed control
(ESC) with reverse
Battery and
Charger
Dynamite ® 7.2V 1200mAh Ni-MH
battery (DYN1472)
Dynamite 2A Peak Charger (DYN4113)
4 AA batteries (sold separately) are
required to operate the transmitter
EN
3
Advertisement
Table of Contents
