Charging The Receiver Battery; Receiver Battery Installation; Antenna Tube Installation - ProBoat ZELOS 48G Owner's Manual

EN

Charging the Receiver Battery

Instructions
Choose a charger designed to charge the included
7.4V 3300mAh 2S 15C LiPo. We recommend the
Dynamite ® Prophet™ Sport LiPo AC Balance Charger
(DYNC2005CA). Refer to your charger manual for
charging instructions and safety information.

Receiver Battery Installation

1. Remove the 2 clips and lid from the battery
compartment.
2. Install the battery in the battery compartment.
3. Connect the battery EC3™ connector to the ON/
OFF switch.
4. Install the lid on the box and secure the lid using
the clips.
IMPORTANT: After boating, always remove the
battery before transporting or storing the boat.
CAUTION: Before boating, use a LiPo voltage
checker (DYN4071) to check your battery charge.
Failure to use a fully charged battery may result in a
runaway boat, which could cause injury to people and
property damage.

Antenna Tube Installation

Install the receiver antenna in the tube as shown. Do not
bend the end of the antenna over the antenna tube and
place the cap over it. The antenna does not have to be
outside of the tube to operate properly.
Keep the end of the antenna above the boat's waterline
to get the best transmitter reception. Apply clear tape
(DYNM0102) if desired.
NOTICE: Do not cut or kink the receiver antenna or
damage may result.
6
NOTICE: Never charge a battery in the boat or
damage may result.
Zelos™ 48-Inch Gas Catamaran