Related Manuals for ProBoat Volere 22
Summary of Contents for ProBoat Volere 22
- Page 1 Owners Manual • Bedienungsanleitung Manuel de l'utilisateur • Manuale dell'utente PRB3050B/ PRB3050BI...
-
Page 2: Table Of Contents
Radio System Check ................6 Compliance Information for the European Union ....... 15 Getting Started ..................7 Identification of Components............56 Binding ....................7 Replacement Parts ................57 Testing your Boat in the Water............8 Optional Parts ................... 57 Volere 22... -
Page 3: Introduction
2. While the stand is level on a flat surface, apply medium CA or epoxy adhesive to secure the side stand pieces to the ends. 3. Allow the adhesive to dry before placing your boat on the stand. Volere 22... -
Page 4: Charging Warnings
Once your battery is properly conditioned through a few full charge and discharge cycles, you will see normal operation of the charger by a single press of the start button, followed by a 60 to 90 minute charge cycle. Volere 22... -
Page 5: Antenna Tube Installation
IMpORTANT: Always remove the battery from the boat for transport and storage. Transmitter Battery Installation This transmitter requires 4 AA batteries. 1. Remove the battery cover from the transmitter. 2. Install the batteries as shown. 3. Install the battery cover. Volere 22... -
Page 6: Transmitter Controls
ESC. The auto-sensing voltage cutoff will also engage when the ESC detects low battery voltage. Release the throttle and recharge the battery. left right throttle brake/reverse Volere 22... -
Page 7: Getting Started
If the receiver is powered on before powering on the transmitter, the receiver will enter failsafe mode, driving the servos to their preset failsafe positions. When the transmitter is powered on, normal control is resumed. Failsafe servo positions are set during binding. Volere 22... -
Page 8: Testing Your Boat In The Water
ESC to prevent of the first battery charge. the cooling tubes, driving against circuit damage, but cannot heavy resistance or debris in the protect the motor from turning drive system. against heavy resistance. Volere 22... -
Page 9: When You Are Finished
2. Lubricate the stuffing tube through the oil fill port near the motor coupler. Only a few drops of household light machine oil are needed. If desired, put a paper towel under the port to capture stray drops. Volere 22... -
Page 10: Driveshaft Maintenance
NOTICE: Because of its corrosive effects, running this product in saltwater is at the discretion of the modeler. Tip: Use paper or cloth to touch the driveshaft. . Remove the rudder from the shaft housing and the driveshaft from the stuffing tube. Volere 22... -
Page 11: Checklists
Battery capacity may be too low Replace battery or use a larger capacity battery for conditions Too little lubrication on driveshaft Fully lubricate driveshaft Vegetation or other obstacles block Remove boat from the water and obstacles the rudder or propeller Volere 22... - Page 12 (LVC) no longer performing Weather conditions might be too cold Postpone until weather is warmer Battery is old, worn out or damaged Replace battery Battery C rating might be too small Use recommended battery Volere 22...
-
Page 13: Limited Warranty
Provided warranty conditions have been met, your Product will be serviced or replaced free of charge. Service or replacement decisions are at the sole discretion of Horizon. Volere 22... -
Page 14: Parts Contact Information
11 Rue Georges Charpak France Horizon Hobby SAS 77127 Lieusaint, France +33 (0) 1 60 18 34 90 info@horizonhobby.com.cn Service/Parts/Sales: Room 506, No. 97 Changshou Rd. China Horizon Hobby – China Shanghai, China 200060 +86 (021) 5180 9868 Volere 22... -
Page 15: Fcc Information
No. HH2012121501 This product must not be disposed of with other waste. Instead, it is the user’s responsibility to dispose of their Product(s): PRB Volere 22 EP 2.4GHz RTR waste equipment by handing it over to a designated Item Number(s): PRB3050BI collection point for the recycling of waste electrical and electronic equipment. -
Page 16: Identification Of Components
Identification of components / Identifizierung der Komponenten Identification des composants / Identificazione dei componenti Volere 22... -
Page 17: Replacement Parts
Washer, 8x3x1.5 mm Windschutzscheibe d'hélice, 8x3x1.5 mm nylon, 8x3x1.5 mm Proboat Volere: PRB3053 Windshield: Volere Pare brise Parabrezza: Volere Windschutzscheibe Steering Wheel: Volere Proboat Volere: PRB3054 Volant Ruota timone: Volere Windschutzscheibe PRB3056 550 Motor: Volere 550er Motor Moteur 550 Motore 550... - Page 18 38320 Created: 04/2013 ©2013 Horizon Hobby, Inc. Pro Boat, the Pro Boat logo, Dynamite and EC3 are trademarks or registered trademarks of Horizon Hobby, Inc.