Connecting The Junction Box - Furuno CI-68 Installation Manual

3. WIRING
3.3

Connecting the Junction Box

The transducer cable is connected to the junction box with an extension cable. After
making the connection, seal the cable gland with putty for watertightness.
Transducer cable (66S1066, no armor)
Vinyl sheath
Rubber gasket
Gland
4P pair cable (66S1067, extension cable, with armor)
Attach crimp-on lugs in the same manner as shown above. Fabricate the armor as fol-
lows.
Anticorrosive
sheath
Solder vinyl wire.
3-4
Cut to suitable length considering location on terminal board.
Junction box
Vinyl tape
Vinyl tape
Transducer cable (no armor)
Armor
Clamp vinyl sheath by cable gland.
Rubber gasket
Gland
To earth terminal (Wing nut)
4P cable (w/armor)
FV1.25-4
*
*
Insulation tube
*
FV5.5-5
To internal earth stud
*
FV2-P4
See interconnection
diagram.