Furuno CI-68 Installation Manual page 41

4. ADJUSTMENTS
BTM TRACK BEAM
Choose sounding beam to use to detect bottom. The choices are [B1] (Beam 1), [B2],
[B3] and [ALL].
PULSE LENGTH
Choose pulse length to use in the water tracking mode. The choices are [NORMAL]
and [LONG].
PWR REDUCTION
Choose [LOW] to reduce output power.
TEMP UNIT
Choose unit of temperature measurement from °C or °F.
PULSE UNIT
Choose unit of distance measurement from nm or km.
CUR FLOW DIR
Choose how to display tide data. [FROM] shows the direction from which the current
is flowing. [TO] shows the direction the current is heading.
BEAM TEST
Choose the beam to test among beam 1, beam 1-2, beam 1-3 and beam 2-3. Press
or to choose the beam to test. "NOW TESTING BEAM XX*" (*: XX = beam num-
ber being tested) appears when a beam is being tested.
LANGUAGE
Choose the interface language, English or Japanese.
SIMULATION
Turn the simulation mode on or off and choose simulation mode parameters.
[OFF]: Disable the simulation mode.
[VARIABLE]: Feeds simulation mode data from the processor to the control unit.
[FIXED]: Use the user-set speed and tide values.
When you choose [VARIABLE] or [FIXED], the message "PRESS FUNCTION KEY
TO EXECUTE." appears. Press the F1 key to start the simulation mode. For [FIXED]
selection, the window to set ship's speed, tide speed (layer 1 to layer 5) and tide di-
rection appears ( , : set a value, : move a digit). And then press the MENU key
to finish the setting. The message "LOADING THE SIMULATION DATA" appears dur-
ing the simulation mode.
RESET SETTINGS
Restore all (except LANGUAGE) default menu settings. Choose [YES] and then press
the F1 key to reset settings. Three beeps sounds when all settings have been reset.
4-7