Furuno CI-68 Installation Manual page 19

Flush mounting
See the outline drawing at the back of this manual.
Monitor unit/control unit
The optional flush mount kit OP06-16 is required.
Type: OP06-16, Code No.: 006-556-300
Name
Fixing metal
Tapping screw
Hex. bolt
1. Cut out hole in mounting location referring to the outline drawings at the back of
this manual.
2. Fasten the fixing metal to the monitor and control units with four hex. bolts
(M4x12).
Monitor unit/control unit, rear view
3. Attach the waterproofing cap (MJ-A10C, supplied as installation materials) to the
CONT port at the back of the monitor unit.
4. Using four tapping screws (5x20), fasten the fixing metal attached at step 2 to the
mounting location.
Monitor unit
For flush mounting of the monitor unit, the following optional kit is required.
Type: OP06-17, Code No.: 006-556-310
Name
Fixing metal
Tapping screw
Hex. bolt
1. Cut out a hole (H207xW287) in the mounting location referring to the outline draw-
ings at the back of this manual.
Type Code. No.
06-021-1311 100-279-611
5x20 000-802-840
M4x12 000-882-040
Hex bolts
Fixing metal
Type
06-021-1321
5x20
M4x12
2. MOUNTING
Qty
1
6
4
CONT port
Code No. Qty
100-279-622
000-802-840
000-882-040
1
4
4
2-5