Transceiver Unit - Furuno CI-68 Installation Manual

2.2

Transceiver Unit

Mounting considerations
• Since the transceiver unit generates heat, install it in a dry, well-ventilated place. The
cooling fans at the top of the unit must not be obstructed, to allow heat to escape.
• This unit is designed for bulkhead mounting to permit dissipation of heat. If bulkhead
mounting is absolutely impossible, mount the unit on the floor leaving at least 50 mm
clearance between it and the floor to permit dissipation of heat.
• This unit weights 19 kg. Reinforce the mounting area, if necessary.
• Leave space around the unit for maintenance and checking. Refer to the drawing at
the back of this manual.
Mounting procedure
1. Weld the steel plate (shipyard supply) with four mounting holes to the bulkhead.
2. Use four bolts and nuts (M10, supplied as installation material) to fix the
transceiver unit to the steel plate described at step 1.
4-
280±0.5
Name Plate
Transceiver unit, mounting dimensions (mm)
Bolt
12
Ø
160
2. MOUNTING
Nut
Steel plate
(local supply)
2-7