Furuno CI-68 Installation Manual page 36

4. ADJUSTMENTS
NMEA2/CIF FORMAT
Choose format of equipment connected to NMEA2/CIF port. The choices are [NMEA]
and [CIF]. When selecting [NMEA] here, the sentences are output with the NMEA ver-
sion selected at [NMEA VERSION]. The baud rate is fixed to 4800 bps. To choose
CIF, set the jumper switch J4 on the PCN Board (66P3924) to CIF.
NAV SOURCE
Choose source of nav data among [AUTO], [GPS] and [LORAN-C]. [AUTO] reads po-
sition data in order of accuracy: GPS>LC.
NAV DATA
Choose source data for calculation of sea tide in the NAV mode.
[SPD]: Speed data from the GPS navigator is used as ground tracking speed to cal-
culate sea tide.
[L/L]: Position data from the GPS navigator is used as ground tracking speed to cal-
culate sea tide.
TIME INTERVAL
Set the time interval for reading position data to use for calculating speed. Effective
when [NAV DATA] above is selected to [L/L]. The choices are 1, 2, 3 and 4 (min).
HEADING DEVICE
Choose [YES] if a heading device is connected to the current indicator. When [YES]
is selected, you can choose [HEAD UP] or [NORTH UP] on the [DISP1] sub menu. For
selection of [NO], the display mode is fixed to [HEAD UP].
FORMAT
When [YES] is selected at [HEADING DEVICE] above, choose the format of the
heading device which is connected to the current indicator. The choices are [AD-10]
and [NMEA].
HDG OUT >0.5kn
Choose type of bearing to output when ship's speed is higher than 0.5 kn. The choices
are [COG] (Course Over Ground) and [HEADING].
HDG OUT <0.5kn
Choose type of bearing to output when ship's speed is lower than 0.5 kn. The choices
are [COG] (Course Over Ground) and [HEADING].
LOG PULSE MODE
Choose the tracking mode to use as source for the log pulse. The choices are [GT/
WT] (ground tracking/water tracking) and [WT] (water tracking).
LOG PULSE OUT
Output log pulse in fore direction or both fore and aft directions.
4-2