Transceiver Unit - Furuno CH-250 Installation Manual

On mounting the control unit separate from the monitor unit, the optional control unit separate kit
is required. Mount the control unit same as the above procedure. See the outline drawing at the
back of this manual to mount.
Type: OP06-15-1.5 NEW Code no.: 006-559-140: with 1.5 m cable
Type: OP06-15-5 NEW
Name
Cable MJ-A10SPF0002-015
MJ-A10SPF0002-050
Bracket 06-021-2112
Mounting Plate 06-021-2111-1
Tapping Screw 5x20
Cosmetic Cap DP-687
Hex. Screw M4x12
Bind Screw M4x10
1.2

Transceiver Unit

1.2.1 General mounting considerations
•
The mounting location should be well ventilated and dry.
•
The unit can be mounted on bulkhead or the deck.
•
Secure the maintenance space shown in drawing below for ease of maintenance and
service.
•
The maximum cable length between the transceiver unit and the raise/lower drive unit cable
is 50 m.
•
The maximum cable length between the transceiver unit and the monitor (interface) unit is
10 m.
1.2.3 Mounting method
Fasten the transceiver unit with four tapping screws (5X20).
For bulkhead mounting, tighten upper tapping screws so there is 5 mm clearance between
bottom of screw head and bulkhead, and screw slots of the unit. Then fasten lower screws.
Code no.: 006-559-150: with 5 m cable
Type
000-142-878
000-131-411
100-281-880-10
100-279-741-10
000-162-608-10
000-165-997-10
000-162-939-10
000-807-331
Code no.
7
Qty Remarks
1 For 1.5 m cable
For 5 m cable
1
1
2
2
4
4 For monitor