Fisher & Paykel DishDrawer DD24D 7 Installation Instructions Manual page 9

TALL HEIGHT INTEGRATED MODELS ONLY - CUSTOM PANEL CALCULATIONS
7b
The following calculations assume the top of the upper panel is
aligned with the top of the adjacent cabinetry. The fi nal
panel/cabinetry alignment is achieved by adjusting the feet:
WIDTH OF ALL PANELS
Measure A (the width between adjacent door/drawer fronts)
and write it in the fi rst box below, then complete the equation.
clearance to adjacent
cabinet front
A
(min. 1⁄16" (2 mm))
- x
2
HEIGHT OF THE UPPER PANEL
B
minimum upper panel extension
height
(0 "/mm recommended)
17 3⁄8"
+
(442 mm)
Note: The 'upper panel extension' B allows for the top of the upper
panel to extend above the chassis where required.
HEIGHT OF THE LOWER PANEL
Measure C (door/drawer height (or equivalent)) and write it in the
fi rst box below, then complete the equation.
C
height of ventilation gap
upper panel
(min. 5⁄16" (8 mm))
(min 30 " (762 mm) + B))
- -
HEIGHT OF THE TOEKICK PANEL
Measure D (height from the top of adjacent cabinet door fronts to the fl oor)
and write it in the fi rst box below, then complete the equation.
B
height from top
upper panel
extension
D
(0"/ mm recommended)
mounting point
-
WIDTH OF PANEL
(min. 23 7⁄16" (596 mm))
=
HEIGHT OF UPPER PANEL
=
HEIGHT OF LOWER PANEL
(min. 12 ¼ " (311 mm)
=
clearance to
of product to
HEIGHT OF TOEKICK PANEL
floor
toekick panel
(min. 2 ¾ " (70 mm))
(min. ½ " (12 mm))
- 3011⁄16" - =
(779 mm)
FRONT PANEL SPECIFICATIONS
5⁄8 - 13⁄16" (16-20 mm) panel thickness
Adequately sealed to withstand moisture (122
Maximum weight of each panel: 20 lb (9 kg)
TOEKICK PANEL SPECIFICATIONS
min. 3⁄8" (9 mm) panel thickness if using supplied screws
Adequately sealed to withstand moisture (122
You may choose to affix your custom toekick panel either by
screwing it to the supplied mounting bracket or gluing it on the
supplied prefinished toekick panel.
min. 1⁄16"(2mm)
C
D
HEIGHT OF
TOEKICK PANEL
min. ½ "(12mm)
clearance to floor
If the toekick recess (dimension
J under 'Product dimensions') is
between 2" and 3 5⁄16" (50 and 84
mm) deep, the toekick panel will
need to be modifi ed for fi tting
around the underside of the
product.
See illustration for details on the
2 3⁄16" (55 mm)
shape of the cutout required.
min. 1⁄16"(2mm)
O F/ 50 O C @ 80% RH)
O O
F/ 50 C @ 80% RH)
A
min. 1⁄16"(2mm)
WIDTH OF ALL PANELS
HEIGHT OF
UPPER PANEL
min. 5⁄16"(8mm)
ventilation gap
HEIGHT OF
LOWER PANEL
J
1 3⁄16-2 "
(30-50 mm)
17" (432 mm)
R ½ " (12.7 mm)
J
2-3 5⁄16"
(50-84 mm)
9
min. 1⁄16"(2mm)
Side
Side