Fisher & Paykel DishDrawer DD24D 7 Installation Instructions Manual page 19

20 ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS
+ or - 1⁄16" (2 mm)
With the front panels fitted, insert an appropriately
sized Philips screwdriver into the hole above the door
pin and rotate the panels up or down to align the gaps
in your cabinetry.
Repeat on the other side if necessary.
Each panel has a maximum travel of 1⁄16" (2 mm) up or
down.
Important!
Ensure that you maintain a minimum of 5⁄16" (8 mm)
ventilation gap between the upper and lower panels.
INTEGRATED MODELS ONLY - INSTALLING THE FRONT PANELS
21 FITTING A CUSTOM TOEKICK PANEL
You can optionally glue your
custom toekick panel onto the
supplied panel
19
16 mm x5 5⁄8" (16mm) x5