Fisher & Paykel DishDrawer DD24D 7 Installation Instructions Manual page 13

SECURE TO THE CABINETRY ON THE SIDES
12a
Open the
drawer halfway.
Using a flat-bladed
screwdriver, prize
the gray
rubber plug out
of the trim moulding.
2
Using a small Philips
screwdriver,
screw through the trim
moulding, securing the
side mounting bracket
to the cabinetry.
Do not damage the
rubber trimseal.
FIT THE SUPPLIED TOEKICK PANEL
14a
Where the toekick
meets the bottom
1
of the tub is the
cut-off point
2
Mark this point
on the toekick
with a pencil
1
Replace the gray
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
Repeat for all
four brackets.
(OPTIONAL FOR INTEGRATED MODELS)
3 5
Lay the toekick face down on
Turn the toekick over and
a chopping board or similiar score along the same line
4
19
Score along with a knife Gently snap off the excess
OPTIONALLY SECURE TO THE CABINETRY ABOVE
13a
3
19
Smooth the edge with a file.
Be careful of sharp edges.
6
Snap off the two end tabs
(x2)
7
8
Slide the toekick onto
the mounting rails
either side and screw
the toekick onto the
bottom of tub on
either side.
Important!
Do not overtighten screw.
13
The top mounting
brackets will only bend
upwards a maximum
of 3⁄8" (10 mm).
Mounting rail
9